Model : 137B23A | ICP® Pressure Sensor

Click for lead times
Lead Time for 6-10 is 8 Wks
quartz, free-field, icp® blast pressure pencil probe, 50 psi, 100 mv/psi, 10-32 connector
$ 1,330.00 USD
(Pricing valid in US only!)

Quartz, free-field, ICP® blast pressure pencil probe, 50 psi, 100 mV/psi, 10-32 connector

  • Measurement Range: 50 psi ( 345 kPa)
  • Sensitivity: (±15%)100 mV/psi ( 14.5 mV/kPa)
  • Resonant Frequency: >=400 kHz
  • Electrical Connector: 10-32 Coaxial Jack
  • Weight: 12.5 oz ( 353 gm)

RELATED PRODUCTS



063A02
063A02

Mounting adaptor for 137 Series Free-field blast probe



Add to Cart for Quote
Add to Cart
079A15
079A15

Microphone stand (with boom attachment & adaptor)



Add to Cart for Quote
Add to Cart
079A17
079A17

Tripod microphone stand



Add to Cart for Quote
Add to Cart
079A18
079A18

Clamp-on flexible extension arm



Add to Cart for Quote
Add to Cart
English: SI:
Performance
Measurement Range (for ±5V output) 50 psi 345 kPa
Useful Overrange (for ± 10V output) 100 psi 690 kPa [ 3]
Sensitivity (±15 %) 100 mV/psi 14.5 mV/kPa
Maximum Pressure 1000 psi 6895 kPa
Resolution 0.01 psi 0.069 kPa [ 2]
Resonant Frequency ≥400 kHz ≥400 kHz
Rise Time (Incident) ≤6.5 µ sec ≤6.5 µ sec
Non-Linearity ≤1.0 % FS ≤1.0 % FS [ 1]
Environmental
Temperature Range (Operating) -100 to +275 °F -73 to +135 °C
Temperature Coefficient of Sensitivity ≤0.05 %/°F ≤0.090 %/°C
Electrical
Discharge Time Constant (at room temp) ≥0.2 sec ≥0.2 sec
Excitation Voltage 22 to 30 VDC 22 to 30 VDC
Constant Current Excitation 2 to 20 mA 2 to 20 mA
Output Impedance ≤100 Ohm ≤100 Ohm
Output Bias Voltage 8 to 15 VDC 8 to 15 VDC
Physical
Sensing Geometry Compression Compression
Sensing Element Quartz Quartz
Housing Material Aluminum Aluminum
Diaphragm Invar Invar
Sealing Epoxy Epoxy
Electrical Connector 10-32 Coaxial Jack 10-32 Coaxial Jack
Weight 12.5 oz 353 gm [ 2]
* All specifications are at room temperature unless otherwise specified
.




Specification Notes


[ 1] Zero-based, least-squares, straight line method.
[ 2] Typical.
[ 3] For +10 volt output, minimum 26 VDC supply voltage required. Negative 10 volt output may be limited by output bias.
[ 2] Typical.
[ 4] See PCB Declaration of Conformance PS023 for details.


Accessories


Supplied
PCS-1 Calibration of dynamic pressure sensors at 20% intervals to full scale, max 15 kpsi range. 0
085A43 Connector protector for series 137B2xA 1